Lenovo ThinkPad Edge 15 - Manual (Page 159)

• NETWK /D disables all network traffic by disabling all network adapters.
• NETWK /E enables all network traffic. Networking will be disabled until a NETWK /E (enable) command
is run.
• NETWK /A restricts networking to the IP address specified by either the /IP switch (dotted decimal) or
/DN (DNS name).
• NETWK /NM provides the network mask. If /NM is not provided, then only the single machine specified
by /IP or /DN will be accessible. The state of this command does not persist over reboots, so networking
must be explicitly enabled and disabled after every reboot.
REBOOT
The REBOOT command allows scripts written by administrators to cause the computer to reboot. The
syntax of this command is as follows:
reboot.exe [/rr | /win] [/wait | /f]
• /rr - boots to the Predesktop Area.
• /win - boots to the operating system immediately (default).
• /wait - boots to the Predesktop Area or operating system when the system is rebooted.
• /f - forces the system to reboot immediately and does not allow the user to close open applications.
Appendix B. Antidote Delivery Manager 151