Sioux Chief Water Heater Stand User Manual
Water heater stand
Water Heater Stand
Model number: 598-011
Tools Needed:
Hammer, Phillips screwdriver,
and 7/16 nut driver
Caution:
Wear gloves when handling stands.
Some edges may be sharp.
Box Contents:
Description
Qty
Platform/Top
1
Legs 18" galvanized steel 18-ga.
4
Cross braces
2
Screw ¼-20 x ½" Phillips
1
Lock washer
1
¼-20 nut
1
Assembly Instructions:
1.
Lay the top (flat side) of platform on floor.
2.
Insert each leg into slots at an angle first
then tilt leg to vertical position and tap into
place
3.
Each leg bottom has an upper and lower
tabbed slots. Insert one cross brace face side
up into bottom slots diagonally and between
two opposing legs
4.
Tap cross brace into place on both ends
5.
Insert second cross brace, face side
down into upper tabbed slots diagonally and
between two opposing legs.
6.
Tap cross brace into place on both ends.
7.
Secure cross braces with bolt, washer and
nut. Tighten firmly.
8.
Turn stand upright. Installation complete.
Water Heater Stand
Model number: 598-011
Tools Needed:
Hammer, Phillips screwdriver,
and 7/16 nut driver
Caution:
Wear gloves when handling stands.
Some edges may be sharp.
Box Contents:
Description
Qty
Platform/Top
1
Legs 18" galvanized steel 18-ga.
4
Cross braces
2
Screw ¼-20 x ½" Phillips
1
Lock washer
1
¼-20 nut
1
Assembly Instructions:
1.
Lay the top (flat side) of platform on floor.
2.
Insert each leg into slots at an angle first
then tilt leg to vertical position and tap into
place
3.
Each leg bottom has an upper and lower
tabbed slots. Insert one cross brace face side
up into bottom slots diagonally and between
two opposing legs
4.
Tap cross brace into place on both ends
5.
Insert second cross brace, face side
down into upper tabbed slots diagonally and
between two opposing legs.
6.
Tap cross brace into place on both ends.
7.
Secure cross braces with bolt, washer and
nut. Tighten firmly.
8.
Turn stand upright. Installation complete.
Note:
Each leg has a pair of holes at the bot-
tom. When required by code, anchor stand to
structure with seismic restraint hardware (not
included).
Important:
Never use or store flammables
within 50 feet of water heater.
#IS-598FA
1-800-821-3944
Note:
Each leg has a pair of holes at the bot-
tom. When required by code, anchor stand to
structure with seismic restraint hardware (not
included).
Important:
Never use or store flammables
within 50 feet of water heater.
#IS-598FA
1-800-821-3944