Kramer Electronics VS-1616A - Manual (Page 45)

Viewing the MENU Commands Sequence
41
41
4. Press the TAKE button again.
The Displays show the messages:
READY to set MACHINE ADDRESS
use OUTkey 1-9, 0
Current #
1
5. Enter the MACHINE ADDRESS by pressing an OUT button # 1-9, 0.
The STATUS Display shows the message:
current:
x
Where x is the OUT button # pressed
6. Press the TAKE button again.
The Displays show the messages:
READY to change MACH. ADDR.
Press TAKE to confirm
From # 01
to # x
At this stage, you can enter another MACHINE ADDRESS by pressing
another OUT button.
7. Press the TAKE button again.
The Displays show the messages:
MACHINE ADDRESS
changed
current #
x
After a few seconds, the Displays show the messages:
SET highest MACHINE ADDRESS
use OUTkey 1-9, 0
current #
x
8. Press an OUT button # 1-9, 0.
The STATUS Display shows the message:
current #
x
Where x is the OUT button # pressed
At this stage, you can enter another highest MACHINE ADDRESS. The
unit may suggest a highest MACHINE ADDRESS for your system. If so,
it is recommended that you use that address.
9. Press the TAKE button again.
The MATRIX Display shows the message:
Change highest MACH. ADDR. ?
Press TAKE to confirm