Kramer Electronics VP-16x18AK - Manual (Page 49)

Kramer Protocol
45 45
Commands chain separator char:
When message string contains more than one command, commands will be separated by pipe ("|").
Commands entering:
If terminal software used to connect over serial \ ethernet \ USB port, that possible to directly enter all commands characters
(CR will be entered by Enter key, that key send also LF, but this char will be ignored by commands parser).
Sending commands from some controllers (like Crestron) require coding some characters in special form (like \X##).
Anyway, there is a way to enter all ASCII characters, so it is possible to send all commands also from controller.
(Similar way can use for URL \ Telnet support that maybe will be added in future).
Commands forms:
Some commands have short name syntax beside the full name to allow faster typing, response is always in long syntax.
Commands chaining:
It is possible to enter multiple commands in same string by '|' char (pipe).
In this case the message starting char and the message closing char will be entered just one time, in the string beginning
and at the end.
All the commands in string will not execute until the closing char will be entered.
Separate response will be sent for every command in the chain.
Input string max length:
64 characters.
Backward support:
Design note: transparent supporting for protocol 2000 will be implemented by switch protocol command from protocol 3000
to protocol 2000, in protocol 2000 there is already such a command to switch protocol to ASCII protocol (#56 : H38 H80 H83
H81).
Table 17: Instruction Codes for Protocol 3000
Help commands
Command
Syntax Response
Protocol Handshaking #CR ~OKCRLF
Device initiated messages
Command Syntax
Start message Kramer Electronics LTD. , Device Model
Version Software Version
Switcher actions
Audio-video channel has switched (AFV mode) AV IN>OUT
Video channel has switched (Breakaway mode) VID IN>OUT
Audio channel has switched (Breakaway mode) AUD IN>OUT
Result codes (errors)
Syntax
No error. Command running succeeded COMMAND PARAMETERS OK
Protocol Errors
Syntax Error ERR001
Command not available for this device ERR002
Parameter is out of range ERR003
Unauthorized access (running command without the match login). ERR004