Kramer Electronics VP-16x18AK - Manual (Page 17)

Connecting and Configuring the VP-16x18AK
13 13
6 Connecting and Configuring the VP-16x18AK
This section describes how to:
• Connect the VP-16x18AK (see
Section 6.1 )
• Connect a balanced stereo audio output (see
Section 6.2 )
• Connect the VP-16x18AK to a remote control device via:
 RS-232 (see
Section 6.3 )
 RS-485 (see
Section 6.4 )
 Ethernet (see
Section 6.5 )
• Set the RS-485 termination and machine number (see
Section 6.6 )
6.1 Connecting the VP-16x18AK
Always switch off the power on each device before connecting it to your
VP-16x18AK. After connecting your VP-16x18AK, connect its power
and then switch on the power on each device.
To connect
1
the VP-16x18AK, as illustrated in the example
2
Figure 3 in :
1. Connect the VGA (up to UXGA) sources (for example, computer
graphics sources) to the 15-pin HD VIDEO INPUT connectors.
2. Connect the unbalanced stereo audio sources (for example, the audio
source of the computer) to the 3.5mm mini AUDIO INPUT jacks.
3. Connect the 15-pin HD VGA VIDEO OUTPUT connectors to the
video acceptors (for example, video displays).
4. Connect the AUDIO OUTPUT terminal block connectors to the
balanced stereo audio acceptors (for example, balanced stereo audio
amplifiers with speakers).
5. If required, you can connect a PC and/or controller to the:
 RS-232 port (see
Section 6.3 )
 RS-485 port (see
Section 6.4 )
 Ethernet port via a LAN (see
Section 6.5 )
6. Connect the power cord
3
Figure 3 (not shown in ).
1 You do not need to connect all inputs and outputs
2 Switch off the power on each device before connecting it to your VP-16x18AK. After connecting your VP-16x18AK,
switch on its power and then switch on the power on each device. Do NOT push in the rear panel PROG button, it is reserved
for service use
3 We recommend that you use only the power cord that is supplied with this machine
i