Kramer Electronics VP-16x18AK - Manual (Page 20)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting and Configuring the VP-16x18AK
16
6.5 Connecting to the VP-16x18AK via the Ethernet Port
You can connect the VP-16x18AK via Ethernet using either of the
following methods:
• Direct connection to the PC using a crossover cable (see
Section 6.5.1 )
• Connection via a network hub, switch or router using a
straight-through cable (see Section 6.5.2 )
Note: The following instructions are valid only if your PC uses a fixed IP
address. If your PC receives an IP address from a DHCP server, consult
your IT department regarding a suitable IP address.
6.5.1 Connecting Directly to the Ethernet Port
You can connect the Ethernet port of the VP-16x18AK to the Ethernet port
on your PC via a crossover cable with RJ-45 connectors.
This type of connection is recommended for identification of the factory
default IP Address of the VP-16x18AK during the initial configuration
To connect the VP-16x18AK directly to a PC using a crossover cable:
1. Using a crossover cable, connect the VP-16x18AK to the PC via the
Ethernet port on both units.
2. On the PC, click Start > Control Panel.
3. Double-click Network Connections.
4. Right-click, and from the menu select Properties.
The Local Area Connection Properties window appears.
5. Select Internet Protocol (TCP/IP) (see Figure 6 ).