Festo Амортизаторы YSRWJ - Manual (Page 17)

YSRWJ-...-A
Festo YSRWJ-...-A 0008NH English
17
5 Commissioning
For precise adjustment of an end position:
S Carry out the following steps:
1. Move to end position under operating
conditions.
2. Use an open-end spanner to loosen the
lock nut on the side of the capstan.
3. Set the desired end position of the move-
able mass as follows:
Direct fitting with the screw thread Indirect fastening in a hole
Turn the capstan nut with a mandrel/
open-end spanner. Turn the loaded lock nut with an open-end
spanner (if necessary, hold the positioning
element against the capstan nut with a
mandrel).
One turn corresponds to approx. 1 mm modification to the stroke.
The following maximum end positions of the
positioning element must be observed here
(see “Fitting mechanical components”).
Fig. 10
Fig. 11