Goulds Pumps 3296 EZMAG - IOM - Manual (Page 68)

Maintenance
1. Frame-to-adapter hex screw (370B)
2. Close-coupled adapter (503)
3. Frame-to-adapter gasket (360W)
Figure 12: Close-coupled pump assembly
Reassemble the liquid end
1. Insert the bearing cartridge (849) into the backplate (444).
1. Backplate (444)
2. Cartridge-to-backplate hex screw (791E)
3. Bearing cartridge assembly (849)
2. Rotate the bearing cartridge until all three holes line up and secure with hex screws (791E).
See Bolt torque values (page 71).
3. For M-group pumps, if the driven carrier pin (445A) in the driven magnet assembly (740A)
must be replaced, then drive in the carrier pin carefully until it protrudes approximately 0.12
in. (3.05 mm) towards the impeller.
66 Model 3296 EZMAG Installation, Operation, and Maintenance Manual