Beijer Electronics SCOM Protocol EN - Manual (Page 98)

Command Reference
98 Elektronik-Systeme Lauer, MAEN976
6.51 LAU_CONFIG_GETLCDCONTROLDISABLE
(0x0120)
Video Controller Control Mode
This command returns the state of the OSD (video controller) keys (i.e.
Supported since Firmware Version
MT223 NAV-230G: 1.0
MT226 NAV-230G: 1.0-DSCALE2
Command Stream
Response Message (Acknowledge)
Response Message (Negative Acknowledge)
Under normal operation conditions, a device never sends a negative acknowledge in
response to this command.
Maximum Lr for this Command
9
Example
Read the OSD keys configuration for the monitor at address 0.7 (group 0, address 7):
According to the data returned by the monitor at address 0.7 (group 0, address 7),
the OSD keys are enabled:
0 1 2 3 4 5 6 7...8 9
0x07 ADR 0x4C 0x41 0x55 0x02 ICHKH 0x01 0x20 ICHKD
0 1 2 3 4 5 6 7 8
0x06 ADR 0x4C 0x41 0x55 0x01 ICHKH Ret ICHKD
Ret
Value: 0x00: OSD keys are enabled
0x01: OSD keys are disabled
Type: Byte
Length: 1
Description: OSD (video controller) keys configuration
0 1 2 3 4 5 6 7...8 9
0x07 0x07 0x4C 0x41 0x55 0x02 0x0D 0x01 0x20 0xDE
0 1 2 3 4 5 6 7 8
0x06 0x07 0x4C 0x41 0x55 0x01 0x0F 0x01 0xFE