Beijer Electronics SCOM Protocol EN - Manual (Page 74)

Command Reference
74 Elektronik-Systeme Lauer, MAEN976
6.30 LAU_CONFIG_GETUDPSNDPORT
(0x010B)
UDP Send Port
All Lauer Navigation Monitors use two UDP ports for sending and receiving SCOM
command and response messages within UDP packets. This setting returns the port
number used to send UDP packets.
Supported since Firmware Version
MT223 NAV-230G: 1.0
MT226 NAV-230G: 1.0-DSCALE2
Command Stream
Response Message (Acknowledge)
Response Message (Negative Acknowledge)
Under normal operation conditions, a device never sends a negative acknowledge in
response to this command.
Maximum Lr for this Command
10
Example
Get the UDP port number used by the monitor at address 0.7 (group 0, address 7)
to send data:
According to the data returned by the monitor at address 0.7 (group 0, address 7),
the monitor uses port 10001 (0x2711) for sending data:
0 1 2 3 4 5 6 7...8 9
0x07 ADR 0x4C 0x41 0x55 0x02 ICHKH 0x01 0x0B ICHKD
0 1 2 3 4 5 6 7...8 9
0x06 ADR 0x4C 0x41 0x55 0x02 ICHKH Ret ICHKD
Ret
Value: 0...65535
Type: Unsigned short
Length: 2
Description: UDP port number for sending data, where the first byte is LSB
0 1 2 3 4 5 6 7...8 9
0x07 0x07 0x4C 0x41 0x55 0x02 0x0D 0x01 0x0B 0xF3
0 1 2 3 4 5 6 7...8 9
0x06 0x07 0x4C 0x41 0x55 0x02 0x0E 0x11 0x27 0xC7