Beijer Electronics SCOM Protocol EN - Manual (Page 78)

Command Reference
78 Elektronik-Systeme Lauer, MAEN976
6.34 LAU_CONFIG_GETDISPLAYADR
(0x010F)
Monitor Address
Returns the software configured monitor address. This address is used, if the monitor
is configured to override the DIL (DIP) switch settings. The returned address does
not contain group information.
Supported since Firmware Version
MT223 NAV-230G: 1.0
MT226 NAV-230G: 1.0-DSCALE2
Command Stream
Response Message (Acknowledge)
Response Message (Negative Acknowledge)
Under normal operation conditions, a device never sends a negative acknowledge in
response to this command.
Maximum Lr for this Command
9
Example
Read the software configured monitor address (excluding group) from the monitor
at address 14.7 (group 14, address 7):
According to the data returned by the monitor at address 14.7 (group 14, address 7),
the monitors software configured address without group is 0x07:
0 1 2 3 4 5 6 7...8 9
0x07 ADR 0x4C 0x41 0x55 0x02 ICHKH 0x01 0x0F ICHKD
0 1 2 3 4 5 6 7 8
0x06 ADR 0x4C 0x41 0x55 0x01 ICHKH Ret ICHKD
Ret
Value: 0...15 (0x00...0x0F)
Type: Byte
Length: 1
Description: Software configured monitor address
0 1 2 3 4 5 6 7...8 9
0x07 0xE7 0x4C 0x41 0x55 0x02 0x2D 0x01 0x0F 0xEF
0 1 2 3 4 5 6 7 8
0x06 0xE7 0x4C 0x41 0x55 0x01 0x2F 0x07 0xF8