Beijer Electronics SCOM Protocol EN - Manual (Page 113)

Command Reference
Elektronik-Systeme Lauer, MAEN976 113
6.60 LAU_CONTROL_ANALOGTOBRT
(0x0204)
Analog to Brightness Routing Control
This command activates or deactivates the backlight level control using the analog
input. The setting is temporary, and does not change the startup analog port usage.
Supported since Firmware Version
MT223 NAV-230G: 1.0
MT226 NAV-230G: 1.0-DSCALE2
Command Stream
Response Message (Acknowledge)
Response Message (Negative Acknowledge)
Under normal operation conditions, a negative acknowledge message does not con-
tain any status data in response to this command. This response message is only sent,
if there is insufficient data in the command stream.
0 1 2 3 4 5 6 7...9 10
0x07 ADR 0x4C 0x41 0x55 0x03 ICHKH 0x02 0x04 Param ICHKD
Param
Value: 0x00: Disable routing from analog input to backlight level
control
0x01: Enable routing from analog input to backlight level
control
Type: Byte
Length: 1
Description: Analog input port usage
0 1 2 3 4 5 6 7...9 10
0x06 ADR 0x4C 0x41 0x55 0x03 ICHKH 0x02 0x04 Ret ICHKD
Ret
Value: 0x00: Routing from analog input to backlight level control
disabled
0x01: Routing from analog input to backlight level control
enabled
Type: Byte
Length: 1
Description: Current analog input port usage
0 1 2 3 4 5 6 7...8 9
0x15 ADR 0x4C 0x41 0x55 0x02 ICHKH 0x02 0x04 ICHKD