Beijer Electronics SCOM Protocol EN - Manual (Page 70)

Command Reference
70 Elektronik-Systeme Lauer, MAEN976
6.26 LAU_CONFIG_GETGWADR (0x0107)
Gateway Address
Returns the configured static gateway IP address. Currently, the gateway address is
not used and internally set to 0.0.0.0.
Supported since Firmware Version
MT223 NAV-230G: 1.0
MT226 NAV-230G: 1.0-DSCALE2
Command Stream
Response Message (Acknowledge)
Response Message (Negative Acknowledge)
Under normal operation conditions, a device never sends a negative acknowledge in
response to this command.
Maximum Lr for this Command
12
Example
Read the static gateway IP-address of monitor at address 0.7 (group 0, address 7):
According to the data returned by the monitor at address 0.7 (group 0, address 7),
the monitor’s static gateway IP-address is 0.0.0.0:
0 1 2 3 4 5 6 7...8 9
0x07 ADR 0x4C 0x41 0x55 0x02 ICHKH 0x01 0x07 ICHKD
0 1 2 3 4 5 6 7...10 11
0x06 ADR 0x4C 0x41 0x55 0x04 ICHKH Ret ICHKD
Ret
Value: 0...255 each byte
Type: Byte array
Length: 4
Description: Gateway IP address, where the first byte is the highest
address field
0 1 2 3 4 5 6 7...8 9
0x07 0x07 0x4C 0x41 0x55 0x02 0x0D 0x01 0x07 0xF7
0 1 2 3 4 5 6 7...10 11
0x06 0x07 0x4C 0x41 0x55 0x04 0x0C 0x00 0x00 0x00 0x00 0xFF