Beijer Electronics SCOM Protocol EN - Manual (Page 93)

Command Reference
Elektronik-Systeme Lauer, MAEN976 93
6.47 LAU_CONFIG_GETREMOTECONTROL
(0x011C)
Remote Control Configuration
This command returns the configuration value that indicates whether the monitor is
configured to act as a remote controller. Lauer Navigation Monitors can be used as
passive devices, but can also be set up as remote controller devices to alter the back-
light level of any other monitor within the network.
Supported since Firmware Version
MT223 NAV-230G: 1.0
MT226 NAV-230G: 1.0-DSCALE2
Command Stream
Response Message (Acknowledge)
Response Message (Negative Acknowledge)
Under normal operation conditions, a device never sends a negative acknowledge in
response to this command.
Maximum Lr for this Command
9
Example
Check if the monitor at address 0.7 (group 0, address 7) is configured to control oth-
er devices remotely within a network:
According to the data returned by the monitor at address 0.7 (group 0, address 7),
the monitor is capable to control other devices remotely within a network:
0 1 2 3 4 5 6 7...8 9
0x07 ADR 0x4C 0x41 0x55 0x02 ICHKH 0x01 0x1C ICHKD
0 1 2 3 4 5 6 7 8
0x06 ADR 0x4C 0x41 0x55 0x01 ICHKH Ret ICHKD
Ret
Value: 0x00: Remote control capability is disabled
0x01: Remote control capability is enabled
Type: Byte
Length: 1
Description: Indicates, whether the monitor is used also as remote controller
0 1 2 3 4 5 6 7...8 9
0x07 0x07 0x4C 0x41 0x55 0x02 0x0D 0x01 0x1C 0xE2
0 1 2 3 4 5 6 7 8
0x06 0x07 0x4C 0x41 0x55 0x01 0x0F 0x01 0xFE