Vaddio BRC-H900 Operating - Manual (Page 72)

A
ppe
ndix
List of Messages
GB 72
Appendix
List of Messages
The following messages may appear on the screen. Take
the necessary measures shown below.
Indicators on the BRC-H900 camera
Messages for the BRC-H900 camera
Messages for video outputs from the BRU-SF10
HD Optical Multiplex Unit
Indicator Meaning/remedies
STANDBY lamp
flashes. The camera stopped moving due to an
error in the pan/tilt mechanism. Reset
the pan/tilt position or turn off the power
of the camera, then turn it on again.
The back tally lamp
flashes. Turn off the power of the camera, then
consult your Sony dealer.
Message Meaning/remedies
Please restart
system! You are prompted to restart the power of
the camera after you changed the setting
of “IMG FLIP” in the SYSTEM menu.
Use the POWER button on the supplied
Remote Commander or the POWER
button on the RM-BR300 Remote
Control Unit to turn the power off, then
on. The changed setting becomes
effective.
PRESET xx OK
(xx = preset position
numbers 01 to 16) When you store the camera settings into
the memory (POSITION 1-16), the
message will appear for two seconds.
One Push WB...OK
(NG) While the white balance is automatically
adjusted, the message will appear. Wait
for a while. When the adjustment is
complete, it will disappear.
FAN STOP!
(The message will
flash in the main
menu.)
Turn off the power of the camera, then
consult your Sony dealer.
CAUTION
COOLING FAN
STOPPED! Turn off the power of the camera, then
consult your Sony dealer.
PRESET (xx) OUT
OF RANGE (xx =
preset position
numbers 01 to 16) This message appears when you preset
the camera position when the pan/tilt
position of the camera is out of range of
the current PAN-TILT LIMIT setting.
This camera position presetting will fail.
Perform the presetting again after
moving the camera within the range of
the PAN-TILT LIMIT setting.
Message Meaning/remedies
Communication
error
Please check
connection • The AC adaptor is not properly
connected to the DC IN 12V
connector on the BRC-H900, or the
AC cord may be disconnected from
the power outlet. Check that the
BRC-H900 is turned on.
• The CCFC-S200 Optical Fiber Cable
connecting the BRC-H900 to the
BRU-SF10 is connected improperly,
or the optical fiber cable may be
damaged.
• Image frequency settings for the
BRC-H900 and the BRU-SF10 may
be different. For details on settings,
see page 20 and 26. After checking
the above conditions, restart the
BRC-H900 and BRU-SF10.
Option card error
Please check option
card This message appears when an
unsupported optional interface card is
inserted in the card slot of the
BRU-SF10. Remove the card after
turning off the BRU-SF10.