Vaddio CONCEAL Wall Mounting System for WallVIEW HD-USB, PowerVIEW HD-22 & 30 - Manual

342-0464 Rev A CONCEAL Wall Mount System for WallVIEW HD-USB PTZ Camera Page 1 of 2
CONCEAL™ Wall Mount System
For the WallVIEW™ HD-USB and the WallVIEW HD-22 or HD-30 HD Camera Systems
Part Numbers:
HD-USB - 535-2100-203 Dark Grey Plastics and Black Wall Bracket
HD-22/30 - 535-2100-204 Light Grey Plastics and Black Wall Bracket
Overview:
The CONCEAL mount for the WallVIEW HD-USB SR camera
system was designed to complement the HD-USB camera and
conceal all cabling, connectors and mounting hardware hang out
the back end. The CONCEAL is a totally awesome addition to the
Vaddio line of camera mounts.
Unpacking:
Carefully remove the mount and all of the parts from the packaging
and identify the following parts:

One (1) CONCEAL Wall Mount L-Bracket (black metal)

One (1) CONCEAL Rear Camera Cable Cover (RCCC)

One (1) 6-32 Flat Head Screw
 Two (2) 800-737 Camera Mounting Screws, ¼” x 20 x 3/8”
( Note: Use only the 3/8” long ¼”-20 screws as provided)

One (1) CONCEAL Lower Cover Plate with Locking Tabs

Four (4) #8 x 1.25” Screws and four (4) Drywall Anchors
 Documentation
Mounting and Installation Instructions for the CONCEAL Wall Mounting System:
Step 1: Determine Camera Mount Location
When locating the camera, consider viewing angles, lighting conditions, possible line of site obstructions and check for in-wall
obstructions where the camera is to be mounted. Pick a mounting location to optimize the performance of the camera. After
determining the optimum location of the camera system, route the required Cat-5e cables from the camera to the head-end.
The Cat-5e cables should feed-through a 1” (25.4mm) opening (circular or square shape) centered in the rectangular slot
located on the rear flange of the CONCEAL Wall Mount Bracket (see Fig. 2). This hole is covered with the RCCC.
Note: Do not cut out the entire rectangular slot opening in the wall! This will not allow the two-lower wall anchors to
correctly fasten the CONCEAL wall mount to the wall (see Fig. 2).
If the bracket is to be mounted on a 2-gang wall box, use the screws supplied with the wall box cover plate to attach the
CONCEAL Wall Mount Bracket. If mounting to drywall with wall anchors, use the four (4) quality wall anchors/screws provided
(see Fig. 2).
Note: The mounting holes are slotted and are 90° opposing to provide easy leveling. Level the mount and
tighten the mounting screws.
Note: Check all Cat-5e cables for continuity in advance of final
connection. Plugging the EZ POWER/VIDEO Cat-5e Cable into
the wrong RJ-45 may cause damage to the camera system and
void the warranty!
Fig. 2: CONCEAL Wall
Mount Bracket: Cabled
and Attached to Wall
Fig. 3: The Vaddio HD Camera
aligned and attached to the
CONCEAL Wall Mount Bracket
using the provided 3/8” x ¼”-20
screws - See Step 2.
I
NSTALLATION AND
U
SER
G
UIDE
Note: The HD-USB is shown in this example, but the
mounts are the same size and shape.
Test and Mark Cables
WallVIEW HD-USB SR
Camera System with the
CONCEAL Wall Mount
ISO Up View
WallVIEW HD-22/30
Camera System with the
CONCEAL Wall Mount
ISO Down View