Vaddio Ceiling Pendant Mount Kit For DomeVIEW™ Indoor Pendant Mount Domes - Manual

Camera and Electronic Products for Integrators
Vaddio, 800-572-2011 Main, 763-971-4464 FAX, www.vaddio.com
Document 341-447 Rev B, Page, 1 of 2
Installation and User Guide
Ceiling Pendant Mount Kit
For DomeVIEW™ Indoor Pendant Mount Domes
Ceiling Mount Kit, Part Number: 998-9300-002
UNPACKING:
Carefully remove all of the parts from the packaging. Unpack and identify the following parts:
A) One (1) Ceiling Bracket
B) One (1) Mounting Flange with 1-½ ” NPT Adapter (2” tall)
C) Four (4) Pan-Head Screws, ¼”-20 x ½”
INSTALLATION:
1. Carefully unpack box, inspect contents for damage and verify that all components are included.
2. Remove the (4) ¼” - 20 screws (C) and set aside.
3. Mount the ceiling bracket (a) to ceiling using the appropriate fasteners (not supplied) for the mounting
surface. If using the ceiling bracket outdoors seal the holes in the back of the box from inside and
outside using a silicone chalk (with a 20yr rating).
4. If using conduit, attach ¾" conduit to the box. If conduit is outdoors, the conduit and connector must
be watertight. Route cabling into box and pull enough cable length to reach into the dome housing.
5. Replace the mounting flange (B). If using the ceiling mount outdoors, run a bead of the silicone
sealant to seal the box from moisture. Install the ¼” - 20 screws (C) and tighten firmly.
6. The mounting adapter fits 1-½” NPT pipe (not supplied). Install the 1-½” NPT pipe between the
mount and the pendant dome enclosure.
7. Refer to the housing instruction sheet to complete the installation.
SAVE THESE INSTRUCTIONS:
The information contained in this manual will help you install your Vaddio DomeVIEW product. If these instructions
are misplaced, Vaddio keeps copies of Specifications, Installation and User Guides and most pertinent product
drawings for the Vaddio product line on the website. These documents can be downloaded from www.vaddio.com
free of charge.
Figure 2:
Exploded View - Components of the
Ceiling Pendant Mount Kit
Figure 1:
Ceiling Pendant Mount Kit with 1-½” NPT Pipe
Adapter Flange
Vaddio Part # 998-9300-002
 Dimensions (H x W x D):
5” (12.7cm) x 5” (12.7cm) x 2” (5.08cm)
Ⓐ
Ⓒ
Ⓑ