Vaddio CONCEAL Wall Mounting System for WallVIEW HD-19 DVI/HDMI - Manual

342-0366 Rev A CONCEAL Wall Mount System for WallVIEW HD-18 and HD-19 Camera Systems Page 1 of 2
CONCEAL™ Wall Mounting System
For Vaddio™ WallVIEW™ HD-18 and HD-19 Cameras
Included in the following Camera Systems:
 WallVIEW HD-18
 WallVIEW HD-18 DVI/HDMI
 WallVIEW CCU HD-18
 WallVIEW CCU HD-18 HD-SDI
 WallVIEW HD-19
 WallVIEW HD-19 DVI/HDMI
 WallVIEW CCU HD-19
 WallVIEW CCU HD-19 HD-SDI
Overview:
The CONCEAL mount for the WallVIEW HD-18 and HD-19 camera systems were aesthetically designed to
complement the cameras and conceal all cabling, connectors and mounting hardware. The CONCEAL mount
comes in both black and white versions to match the cameras. The CONCEAL is a totally awesome addition to
the Vaddio line of camera mounts.
Unpacking:
Carefully remove the mount and all of the parts from the packaging. Unpack and identify the following parts:
 One (1) CONCEAL Wall Mount Bracket
 One (1) CONCEAL Rear Camera Cover
 One (1) CONCEAL Lower Cover Plate with Locking Tabs
 Four (4) #8 x 1.25” Screws and four (4) Drywall Anchors
 Documentation
Mounting and Installation Instructions for the CONCEAL Wall Mounting System:
Step 1: Determine Camera Mount Location
When locating the camera, consider viewing angles, lighting conditions, possible line of site obstructions and
check for in-wall obstructions where the camera is to be mounted. Pick a mounting location to optimize the
performance of the camera. After determining the optimum location of the camera system, route the required Cat-
5e cables from the camera to the head-end. The Cat-5e cables should feed-through a 1” (25.4mm) opening
(circular or square shape) centered in the rectangular slot located on the rear flange of the CONCEAL Wall Mount
Bracket (see Fig. 2).
Note: Do not cut out the entire rectangular slot opening in the wall! This will not allow the two-lower wall
anchors to correctly fasten the CONCEAL wall mount to the wall (see Fig. 2).
If the bracket is to be mounted on a 2-gang wall box, use the screws supplied with the wall box cover plate to
attach the CONCEAL Wall Mount Bracket. If mounting to drywall with wall anchors, use the four (4) quality wall
anchors/screws provided (see Fig. 2). Note: The mounting holes are slotted and are 90° opposing to provide
easy leveling. Level the mount and tighten the mounting screws.
Note: Check all Cat-5e cables for continuity in advance of final connection. Plugging the EZ
POWER/VIDEO Cat-5e Cable into the wrong RJ-45 may cause damage to the camera system and void
the warranty!
Fig. 2: CONCEAL Wall Mount Bracket:
Cabled and Attached to Wall
Fig. 3: Vaddio HD-18 Camera
aligned and attached to the
CONCEAL Wall Mount Bracket
Figure 1:
WallVIEW HD-19AW
and WallVIEW HD-18
with CONCEAL
Mounting Systems in
both black and white
I
NSTALLATION AND
U
SER
G
UIDE