American Power Conversion PD150G6F - Manual (Page 60)

52 150kW InfraStruXure PDU—Operation and Configuration
How to Add Circuit Breakers and Power
Cables
Add a circuit breaker on the PDU
1. Snap and bolt the new
circuit breaker into a
position on the panel.
2. Remove the
corresponding plastic
blanking plate on the
front panel of the PDU.
Add a power cable to the PDU
Before adding a power cable, add a circuit breaker.
1. Install a strain-relief connector in any
available knockout on the roof of the
PDU.
2. Slide enough of the power cable through
the strain-relief connector to reach the
new circuit breaker.
3. Tighten the strain-relief connector.