Panasonic HX-A500H - Manual (Page 53)

- 53 -
To set the image quality
≥ Select [Details] in the [LIVE CAST] menu. ( l 52 )
1 Move the joystick to select [IMAGE QUALITY], then press the joystick.
2 Select the desired image quality, then press the joystick.
≥ Frame rate in parentheses are when recorded simultaneously.
≥ Depending on the line status of the broadband line, mobile router (tethering), etc. to which this
unit is connected, the image and sound may be interrupted or the connection may be lost. Set the
image quality on this unit by referring to the recommended optimal speeds (upstream) above.
≥ For information on the optimal speed, contact your service provider, etc.
≥ If the image being broadcast appears as if frames were dropped or stops when [AUTO] is set,
change [IMAGE QUALITY] according to your environment.
≥ If the selected image quality has an image quality higher than the one you are using, images will
appear as if the frame rate is low.
≥ Operation cannot be guaranteed for all devices.
≥ Even with a broadband line, the recommended optimal speed may not be reached depending on
your environment.
≥ Narrowband lines such as analog modems cannot be used.
≥ If the line for the smartphone is switched, communication may be interrupted. In that case,
connect again.
To set the image quality of a motion picture you simultaneously broadcast and
record
≥ Select [Details] in the [LIVE CAST] menu. ( l 52 )
1 Move the joystick to select [RECORD SETUP], then press the joystick.
2 Select the desired pixels/frame rate, then press the joystick.
≥ You cannot change the live broadcast settings during recording or a live broadcast.
Image Quality Resolution Frame rate
Recommended optimal
speed (upstream)
[AUTO] Use this option to check the image quality and automatically set the item.
[HIGH] 1280 k720
5 to 30 fps
(5 to 10 fps)
3 Mbps or higher
[MEDIUM] 640 k360
5 to 30 fps
(5 to 10 fps)
1 Mbps or higher
[LOW] 320 k176
5 to 30 fps
(5 to 15 fps)
500 kbps or higher
[1920 k1080/30p]/[1280k720/30p]/[848k480/30p]