Karcher B 60 W Bp Pack - Manual (Page 32)

– 10
This function is required for operating the
spray suction attachment (accessory).

Turn the info button clockwise until
"WDB-Funktion" or "WDB-Function" is
displayed.
 Shortly press the info button.
 Select "ON" or "OFF" by turning the info
button.
 Press the info button to confirm the set
value.
If the operational break exceeds 30 min-
utes, the machine goes into stand-by
mode. To restart the machine, turn the key
switch briefly to "0" and then turn it again to
"1".
 Close the regulatory button for setting
the water quantity.
 Release driving lever.
 Lift the cleaning head.
 Briefly drive forward and suck of the re-
maining water.
 Raise the vacuum bar.
The suction turbine will continue to run
for 5 more seconds to suck off residual
water from the vacuum bar and the vac-
uum hose.
 Apply parking brake (optional). Press
the pedal downwards and move it to the
right to lock it.
 Set the key switch at the operator con-
sole to "0" and remove the key.
 Charge battery, if required.
ṇ
Warning
Please observe the local provisions regard-
ing the wastewater treatment.

Take the water discharge hose from the
support and lower above a suited col-
lection device.
 Crush or bend the dosing equipment.
 Open the lid of the dosing equipment.
 Drain off the dirt water - regulate the wa-
ter quantity by pressing or bending.
 Rinse the dirt water tank with clear wa-
ter.
 Loosen the lid for emptying the fresh
water - do not remove it fully. Drain wa-
ter.
 Remove the lid with washer fully to
rinse off the fresh water tank.
Turning on/off WDB
Stand-by
Shutting Down the Appliance
Drain off dirt water
Drain off clean water
32 EN