Led disable/enable send_commands, Port assignments by ni model, Rs232/422/485 ports channels – AMX NI-2100/3100/4100 User Manual
Page 87
Programming
79
NI Series WebConsole & Programming Guide
LED Disable/Enable Send_Commands
The following commands enable or disable the LEDs on the Integrated Controller. In the examples:
Port Assignments By NI Model
RS232/422/485 Ports Channels
RS232/422/485 ports are Ports 1-2 (NI-700) and Port 1 (NI-900).
The following sections only apply to the integrated controller component of the NIs.
LED Send_Commands
Command
Description
LED-DIS
Disable all LEDs (on 32 LED
hardware) for a port.
Regardless of whether or not the port is active, the LED will not be lit. Issue this
command to port 1 to disable all the LEDs on the Controller. When activity
occurs on a port(s) or Controller, the LEDs will not illuminate.
Syntax:
SEND_COMMAND
Example:
SEND_COMMAND Port_1,"'LED-DIS'"
Disables all the LEDs on Port 1 of the Controller.
LED-EN
Enable the LED (on 32 LED
hardware) for a port
When the port is active, the LED is lit. When the port is not active, the LED is
not lit. Issue the command to port 1 to enable the LEDs on the Controller
(default setting). When activity occurs on a port(s) or Controller, the LEDs
illuminate.
Syntax:
SEND_COMMAND
Example:
SEND_COMMAND System_1,'LED-EN'
Enables the System_1 Controller's LEDs.
Port Assignments By NI Model
NI Model
RS-232/422/485
IR/Serial
IR/RX
Relays
I/O
NI-700
Ports 1 - 2
Port 3
Port 5
Port 4
NI-900
Port 1
Ports 2-4
Port 6
Port 5
NI-2000
Ports 1-3
Ports 5-8
Port 4
Port 9
NI-3000
Ports 1-7
Ports 9-16
Port 8
Port 17
NI-4000
Ports 1-7
Ports 9-16
Port 8
Port 17
NI-2100
Ports 1-3
Ports 5-8
Port 4
Port 9
NI-3100
Ports 1-7
Ports 9-16
Port 8
Port 17
NI-4100
Ports 1-7
Ports 9-16
Port 8
Port 17
RS232/422/485 Ports Channels
255 - CTS push channel
Reflects the state of the CTS input if a 'CTSPSH' command was sent to the
port.