Hubbardton Forge 138810 - Manual (Page 4)

Assembly & Installation Instructions
A334
Apparatus 3 light 13-8810 Page 4 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 28308
To Complete Fixture Assembly
OPTION 2: GLASS SIDE UP (Figures 6 & 7)
Component Parts
D ¼” Dia Rod
E ½” Dia Ball
O Counterweight
P Block
Q Body
R Set Screw
S Thumb Screw
U Glass
W Shield
1. To install fixture with the glass side up, the orientation of the block (P) must
be changed (Figure 7). Set fixture body (Q) on a flat surface.
2. Loosen set screw (R). Carefully flip block (P) over. Make sure that the
block stays the same distance from the counterweight (O) and glass (U).
Make sure that the top of the block is parallel to the top of the fixture body
(Q).(Figure 7) Retighten set screw (R).
3. Remove ball (E) from rod (D).
4. Loosen Thumb screw (S) from block (P). Orient fixture body (Q) with glass
side down, slide fixture body (Q) up on to rod (D), slipping the fixture body
(Q) over the shield (R). Adjust to desired height and tighten thumb screw
(M).
5. Repeat step 2 for other two fixture bodies (Q).
6. Reattach ball (C) onto the
rod (B).
7. Restore electricity at main
breaker.
If you need further assistance, or find
that you are missing any parts, please
contact the dealer from which you
purchased this product. We hope you
enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 6)
(Figure 7)