Hubbardton Forge 161140 User Manual

A366, Installation instructions

H U B B A R D T O N F O R G E . C O M

hand-forged, vermont-made lighting and accessories

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

30860A

Installation Instructions

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

To Install the Canopy

(Figure 1)

Component Parts

A Crossbar

B Ground Screw

C Cupped Washer

D Canopy

E #8 Screws

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.

1. Carefully unpack the fixture from the carton.

2. Crossbar (A) is shipped installed. Remove screws (E) from
canopy (D) and save for later use. Remove crossbar (A).

3. Using two machine screws (not provided), fasten the cross
bar (A) to the electric box. (Figure 1)

Note: A new electric box comes with screws. When replacing a

fixture, retain the existing screws for use with the new fixture.

4. Height of fixture can be set before attaching the fixture to

the ceiling.

Note: Fixture is shipped at max height.

5. Loosen safety nut on canopy gripper (G) by twisting counter

clockwise. Push supply/support cable (H) into canopy

gripper (G) until desired height is reached.

6. Retighten safety nut on canopy gripper (G).

7. Using suitable wire connectors (not provided) connect fixture

wires to supply wires (white to white, black to black). Run a

pigtail lead from crossbar ground screw (B) to the junction

box and connect all ground wires (bare copper or green to

bare copper or green). (Figure 1)

CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRE IS EXPOSED.

A366

Helix Pendant 161140

Page 1 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

(Figure 1)

(Continued)

F Fixture

G Canopy Gripper

H Supply/Support Cable

B
D

SAFETY
NUT