Hubbardton Forge 364901 - Manual

Assembly & Installation Instructions
A236
For Twilight Semi-Flush 36-4901 & 12-4910 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 24402 Rev B
To Prepare Fixture for Installation (Figure 1)
Component Parts
A Bottom Assembly
B Canopy
C Screws (2)
D Socket
Caution: Be sure power is off at the main breaker box prior to installation
1. Carefully unpack the fixture from the carton.
2. Loosen the two screws (C) located next to the socket (D) and turn the
bottom assembly (A) counter clockwise until the heads of the screws
(C) are located at the larger diameter of the slot and remove
from the canopy (B). It is not necessary to remove the screws.
3. Save all parts for later use.
To Install Fixture (Figure 2)
Component Parts
B Canopy
E Ground Screw
F Cross Bar
G Threaded Stud (2)
H Barrel Knobs (2)
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Thread studs (G) through appropriate holes in cross bar (F) to
match hole centers in canopy (B). Move ground screw (E) to
another available threaded hole if necessary.
2. Using two machine screws (not provided) fasten cross bar (F)
to the electric box using outer oval holes to orient fixture to
desired hanging position.
Note: A new electric box comes with
screws. When replacing an existing fixture, retain the screws for
use with the new fixture.
3. Using suitable wire connectors (not provided); connect fixture wires to supply wires (white to white and black to
black). Run a pigtail lead from crossbar ground screw (E) to the junction box and connect all ground wires (bare
copper or green to bare copper).
Caution: Make sure wire connectors are twisted on securely, and no bare wire
is exposed.
4. Slide fixture canopy (B) over threaded studs and push firmly to ceiling, making sure that no wires are pinched
between fixture canopy and ceiling. Fasten with barrel knobs (H). Be sure studs (G) are fully seated in barrel
knobs (H).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)