Hubbardton Forge 205762 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 28858
Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Please Note: This fixture is designed to be mounted on a standard
wall surface and may not be suitable for all applications. If installing in
a non-wood frame application, we recommend consulting a qualified
builder or electrician.
To Mount Fixture to Wall and Install Glass (Figure 1)
Component Parts
A Glass D Decorative Cage
B Ground Screw E Mounting Screw (2)
C Crossbar F Fixture Back
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Carefully unpack the fixture from the carton.
Note: Not all of included hardware is used during installation.
2. Using two machine screws (not provided), fasten the cross-
bar (C) to the electric box making sure that fixture mounting
holes are level.
Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
3. Hold the fixture back (F) close to the wall and using suitable
wire connectors, not provided, connect two sets of fixture
wires to supply (whites to white and blacks to black). Run a
pigtail lead from crossbar ground screw (B) to the junction
box and connect all ground wires (bare copper or green to
bare copper or green).
CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRE IS EXPOSED.
4. Push fixture assembly firmly to wall, making sure that no
wires are pinched between fixture back and wall. Align
mounting screws (E) with holes in fixture back and thread
into crossbar (C) until fixture is tight against the wall.
B297
Byron’s Leaves Sconce LED 205762D Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Continued)
A
B
C
D
E
F