Hubbardton Forge 18450 D User Manual

A343, Assembly & installation instructions

h u b b a r d t o n f o r g e . c o m

hand-forged, vermont-made lighting and accessories

154 rt. 30 South

•

caStleton, Vermont 05735

28828

Assembly & Installation Instructions

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Stem Assembly

(Figure 1)

Component Parts

a fixture Pipe

b fixture coupling

1. carefully unpack the fixture from the carton.

2. carefully thread fixture pipe (a), threaded end first, over

fixture wires.

3. apply a drop of the supplied thread locking compound to

the internal threads of fixture coupling (b) and screw stem

into fixture, being careful not to twist or pinch the wires.

Note: Application of the thread locking compound is necessary

to prevent the stem from loosening during regular maintenance and
cleaning of the fixture. Be certain to apply the compound.

4. See instructions below to complete the installation.

A343

For Mobius Adjustable Pendant LED 18450D

Page 1 of 3

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. this product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

caution: do not exceed maximum wattage noted on fixture. use only recommended bulbs with fixture.

(Figure 1)

Complete Assembly & Install Fixture

(Figures 2 & 3)

Component Parts

a fixture Pipe

c crossbar

d driver

e cupped Washer

f ground Screw

CAUTION: Be sure power is off at the main Breaker Box prior
to installation.

1. using two machine screws (not provided), fasten the crossbar

& driver (c & d) to the electric box (figure 3).

Note: A new electric box comes with screws. When replacing a

fixture, retain the existing screws for use with the new fixture.

g fixture bracket

h # 8 Screw

I canopy Pipe

J canopy

K canopy ring

l Plastic Sleeve

m clutch

n Set Screw

(Figure 2)

(Figure 1)