Hubbardton Forge 205762F - Manual

Installation Instructions
B75
Byron’s Leaves Sconce 20-5762 & 20-5762F Page 1 of 1
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 19415
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall and Install Glass (Figure 1)
Component Parts
A Glass D Fixture Assembly
B Crossbar E Mounting Screw (2)
C Ground Screw
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Carefully unpack the fixture from the carton.
Note: Not all of included hardware is used during installation
2. Using two machine screws (not provided), fasten the crossbar
(B) to the electric box making sure that fixture mounting holes
are level.
Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
3. Hold the fixture assembly (D) close to the wall and using
suitable wire connectors, not provided, connect fixture wires to
supply (white to white or ribbed and black to black or smooth).
Run a pigtail lead from crossbar ground screw (C) to the junction
box and connect all ground wires (bare copper or green to bare
copper or green).
Caution: Make sure wire connectors are twisted on securely,
and no bare wire is exposed.
4. Push fixture assembly (D) firmly to wall, making sure that no
wires are pinched between fixture back and wall. Fasten fixture
assembly (D) to Crossbar (B) with mounting screws (E) until the
fixture is tight against the wall.
5. Install light bulb (not included/GU24 bulb included on F
version)
6. Slide glass (A) downward slowly into cage. Leaves may need to be lifted or pulled out slightly for glass to slide
smoothly. Glass will stop once it rests on the tabs of the cage.
7. Restore electricity at main breaker
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
*
Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
Figure 1