Hubbardton Forge 207430 User Manual

B321, Assembly & installation instructions

H U B B A R D T O N F O R G E . C O M

hand-forged, vermont-made lighting and accessories

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

30648

Assembly & Installation Instructions

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Please Note: This fixture is designed to be mounted on a standard wall

surface and may not be suitable for all applications. If installing in a non-

wood frame application, we recommend consulting a qualified builder

or electrician.

Please Note: After installation, extra hardware and accessories may be

left due to kits being used on multiple products.

To Mount Fixture to Wall

(Figure 1)

Component Parts

A Fixture

B Mounting Bracket

C Anchors (4)

D #10 Screws (4)

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.

1. Carefully unpack the fixture from the carton.

2. Fixture may be mounted directly to junction box or mounted

to the wall using anchors (Figure 1)

3. To mount directly to junction box: Position the mounting

bracket (B) over the electrical box aligning ovals in bracket

with mounting holes in electrical box.

4. Using two machine screws (not provided) fasten the mount-

ing bracket (B) to the electric box.

Note: A new electric box comes with screws. When replacing an
existing fixture, retain screws for use with the new fixture.

5. To mount to wall using anchors: Place the mounting bracket

(B) over the electrical box being sure to hold it plum and

level. With a pencil, mark the location of all mounting

holes in the mounting bracket (B) on the wall behind.

Important: Wall mounting bracket must be secured to a solidly

mounted to a framing member in at least two locations. Do not

depend on drywall anchors alone to support this fixture. If in doubt,

contact a qualified electrician.

6. Drill 1/4" holes in the locations marked on the wall. For holes

using anchors, place the tapered end of the anchors (C)

into the holes and gently tap them flush to the wall using

a light weight hammer.

B321

Helix Sconce 207430

Page 1 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

(Figure 1)

(Continued)

E Cupped Washer

F Ground Screw

G #8 Black Screws (2)

MACHINE
SCREWS