Hubbardton Forge 161090T - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
30430 Rev A
Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
To Install as part of a Track Lighting System (Figure 1)
Component Parts
A Track Adapter
B Supply/Support Cable
C Fixture
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Carefully unpack the fixture from the carton.
2. Determine desired finished height of fixture.
3. Using a sharp pair of cutters, cut the end of the coaxial
cable off square and clean at the desired length. This
will change the profile of the end of the coaxial cable and
prepare it for insertion into the track adapter.
Follow the instructions on the included instruction sheet:
Installation Instructions for Edge Lighting Fast Jack Male
Coaxial Fixture Connector, document # 904-FJ-MC-04. To
be used with Edge Lighting monorail systems MT 300-12 or
MT-600-24.
The product (luminaire) is intended to install on NRTL (UL, CSA,
ETL, etc.) approved Edge Lighting Monorail System using Edge
Lighting Fast Track connector model# FJ-MC-BZ. The product
gets power from Edge Lighting Surface Magnetic Transformer
model# MT-600-24, or Surface Magnetic Transformer model#
MT-300-12, or Tech Lighting Monorail Surface Mount Trans-
former model# 700MOKTS300S, or 700MOSRT324DC, or WAC
LM-K8111 250 Watt Max, or LBL FUSIONKITSC8ST, 300 watt
Electronic Transformer or TRANSDIR-SFM600SC/24V, 600 Watt
Magnetic Transformer, or similar UL 2108 & CSA C22.2# 9.0 ap-
proved transformer, or any NRTL approved (UL, CSA, ETL, etc.)
CLASS 2 Transformers.
A354
Staccato Pendant Vintage Platinum: 161090T Page 1 of 4
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Continued)
B
C
A