Hubbardton Forge 306420 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 30032
Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
Please Note: This fixture is designed to be mounted on a standard
wall surface and may not be suitable for all applications. If installing in
a non-wood frame application, we recommend consulting a qualified
builder or electrician. Fixture should be mounted four feet above grade.
After installation extra hardware and accessories are possible; our kits
are used on multiple products and options.
To Install Fixture (Figures 1 - 3)
Component Parts
A Fixture Front
B Slotted Screw
C Fixture Back
D Top Screw
E Mounting Bracket
F #8 Screw (4)
G #8 Countersunk Screw (2)
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Carefully unpack the fixture from the carton.
2. Loosen the slotted screw (B) in the bottom of the fixture until
the fixture front (A) is loose. Also remove top screw (D) from
top of fixture. Remove the fixture front (A) from the fixture
back (C) (Figure 1).
Note: Fixture front (A) and screws (B&D) ship installed. Retain for
later use.
3. Center the mounting bracket (E) over the electrical box
being sure to hold it plum and level. With a pencil, mark the
location of all mounting holes in the wall mount bracket on
the wall behind.
IMPORTANT: Wall mount bracket must be secured to a solidly
mounted electrical box and/or a framing member in at least two
locations. Do not depend on drywall anchors alone to support this
fixture. If in doubt, contact a qualified electrician.
Put the mounting bracket down and drill 1/4" diameter holes
in the locations marked on the wall. For holes using
anchors, place the tapered end of the anchors (L) into the
holes and gently tap them flush to the wall using a light
weight hammer.
B302
Double Axis LED Outdoor Sconces: 306415D & 306420D Page 1 of 4
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Continued)
C
B
D
A
H Ground Screw
I Cupped Washer
J Driver
K Gasket
L Anchors (4)
M #10 Screws (4)
N Caulking Lip
O Rubber Washers (3)