Hubbardton Forge 206730D User Manual

B301, Installation instructions

H U B B A R D T O N F O R G E . C O M

hand-forged, vermont-made lighting and accessories

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

28862

Installation Instructions

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Please Note: This fixture is designed to be mounted on a standard wall

surface and may not be suitable for all applications. If installing in a non-

wood frame application, we recommend consulting a qualified builder

or electrician.

To Mount Fixture to Wall & Install Glass

(Figure 1)

Component Parts

A Glass

F Ground Screw

B Top Adjusting Nut G Mounting Screw (2)

C Bent Bracket (top) H Bottom Adjusting Nut

D Textured Bar I Bent Bracket (bottom)

E Crossbar

J Support Bar

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.

1. Carefully unpack the fixture from the carton.

2. Using two machine screws (not provided), fasten the

crossbar (E) to the electric box making sure that fixture

mounting holes are level.

Note: A new electric box comes with screws. When replacing a

fixture, retain the existing screws for use with the new fixture.

3. Hold the fixture assembly close to the wall and using

suitable wire connectors, not provided, connect fixture wires

to supply (whites to whites and blacks to blacks). Run a

pigtail lead from crossbar ground screw (F) to the junction

box and connect all ground wires (bare copper or green to

bare copper or green).

CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY, AND NO BARE WIRE IS EXPOSED.

Push fixture assembly firmly to wall, making sure that no

wires are pinched between fixture back and wall. Fasten

fixture assembly to Crossbar (E) with mounting screws (G)

until the fixture is tight against the wall.

5. Orient the two bent brackets (C & I) to a horizontal position.

B301

Forged Vertical Bar, LED 206729D & 206730D

Page 1 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

(Figure 1)

(Continued)

I
J

This manual is related to the following products:

206729D