Hubbardton Forge 18450 - Manual

Assembly & Installation Instructions
A241
For Mobius Adjustable Pendant 18-450 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 24425
Stem Assembly (Figure 1)
Component Parts
A Fixture Pipe
B Fixture Coupling
1. Carefully unpack the fixture from the carton.
2. Carefully thread fixture pipe (A), threaded end first, over fixture wires.
3. Apply a drop of the supplied thread locking compound to the internal threads of
fixture coupling (B) and screw stem into fixture, being careful not to twist or
pinch the wires.
Note: Application of the thread locking compound is necessary to prevent the
stem from loosening during regular maintenance and cleaning of the fixture. Be
certain to apply the compound.
4. See instructions below to complete the installation.
Prepare the Canopy (Figure 2)
Component Parts
C Jam Nut
D Crossbar
E Threaded
Nipple
F Canopy
G Canopy
Ring
Caution: Be sure power is off at the main breaker box prior to installation.
1. Thread jam nut (C) and crossbar (D) onto threaded nipple (E); leave both parts
loose.
2. Using two machine screws (not provided), temporarily fasten the crossbar (D) to
the electric box. Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
3. Adjust the length of threaded nipple (E) in crossbar (D) so that canopy ring (G)
will hold canopy (F) against the ceiling with no threads showing for best
appearance. When the correct adjustment is established, tighten jam nut (C)
against crossbar (D) to hold the adjustment.
4. Remove the crossbar and stem from the electrical box and proceed with the
assembly instructions.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)
(Figure 1)