Hubbardton Forge 206440 User Manual

B296, Installation instructions

H U B B A R D T O N F O R G E . C O M

hand-forged, vermont-made lighting and accessories

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

28808

Installation Instructions

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Please Note: This fixture is designed to be mounted on a standard

wall surface and may not be suitable for all applications. If installing in

a non-wood frame application, we recommend consulting a qualified

builder or electrician. Fixture should be mounted four feet above grade.

After installation extra hardware and accessories are possible; our kits

are used on multiple products and options

To Install Fixture

(Figures 1 & 2)

Component Parts

A Fixture Front

B Slotted Screw

C Fixture Back

D Top Screw

E Mounting Bracket

F #8 Screw (4)

G #8 Countersunk Screw (2)

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.

1. Carefully unpack the fixture from the carton.

2. Loosen the slotted screw (B) in the bottom of the fixture until

the fixture front (A) is loose. Remove top screw (D) from top

of fixture. Remove the fixture front (A) from the fixture back

Note: Fixture front (A) and screws (B&D) ship installed. Retain for

later use.

3. Center the mounting bracket (E) over the electrical box

being sure to hold it plum and level. With a pencil, mark the

location of all mounting holes in the wall mount bracket on

the wall behind.

IMPORTANT: Wall mount bracket must be secured to a solidly
mounted electrical box and/or a framing member in at least two
locations. Do not depend on drywall anchors alone to support this
fixture. If in doubt, contact a qualified electrician.

Put the mounting bracket down and drill 1/4" diameter holes

in the locations marked on the wall. For holes using

anchors, place the tapered end of the anchors (L) into the

holes and gently tap them flush to the wall using a light

weight hammer.

B296

Double Axis LED Sconce: 206440D

Page 1 of 4

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

(Figure 1)

(Continued)

H Ground Screw

I Cupped Washer

J Driver

K Gasket

L Anchors (4)

M #10 Screws (4)