Hubbardton Forge 126747 - Manual

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH • CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge ® . All rights reserved. 30435
Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
To Install Fixture (Figure 1)
Component Parts
A Fixture
B Mounting Bracket
C Anchors (4)
D #10 Screws (4)
E #8 Screws (4)
F Ground Screw
G Cupped Washer
K Safety Cable
L Short #8 Black Screw (from kit bag)
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Carefully unpack the fixture from the carton.
2. Remove screws (E) from mounting bracket (B) and
remove from fixture. Keep screws for later use. Bracket
ships installed.
3. Place the mounting bracket (B) over the electrical box. With
a pencil, mark the location of all mounting holes in the
mount bracket (B) on the ceiling.
Important: Mounting brackets must be secured to a solidly
mounted to a framing member in at least two locations. Do
not depend on drywall anchors alone to support this fixture. If in
doubt, contact a qualified electrician.
4. Drill 1/4" holes in the locations marked on the ceiling.
For holes using anchors, place the tapered end of the
anchors (C) into the holes and gently tap them flush
to the ceiling using a light weight hammer.
5. Thread the wires in the electrical box through the hole in the
mounting bracket (B) while moving the bracket into position.
Using two machine screws (not provided) fasten bracket (B)
to the electric box using outer oval holes to orient
fixture to desired hanging position. Ensure the anchor holes
in the mounting bracket (B) line up with the anchors
(C) installed in the ceiling.
Note: A new electric box comes with screws. When replacing an
existing fixture, retain the screws for use with the new fixture.
A356
For Semi-Flushes 126747D & 126742D Page 1 of 3
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Continued)
C
G
K
D
E
F
L
B
A