Hubbardton Forge 161080 User Manual
A341, Installation instructions

H U B B A R D T O N F O R G E . C O M
hand-forged, vermont-made lighting and accessories
154 RT. 30 SOUTH
•
CASTLETON, VERMONT 05735
All designs and images ©1989-2013 Hubbardton Forge
®
. All rights reserved.
28727 C
Installation Instructions
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
To Install the Canopy
(Figures 1 & 2)
Component Parts
A Crossbar
B Ground Screw
C Cupped Washer
D Canopy
E #8 Screws
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.
1. Carefully unpack the fixture from the carton.
2. Crossbar (A) and canopy (D) ship attached. Remove (2) #8
screws (E) to separate the canopy (D) from the crossbar (A).
Retain screws (E) for later use.
3. Using two machine screws (not provided), fasten the cross-
bar (A) to the electric box.
Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture
4. Height of fixture can be set before attaching the fixture to
the ceiling. Remove screws w/lock washers (O) and canopy
plate (N) from canopy (D). If height is going to stay at max
length or just a slight height adjustment is needed it may not
be necessary to remove the canopy plate
Note: Fixture is shipped at max height.
5. Push supply/support cable (H) into canopy gripper (G) until
desired height is reached.
6. Coil supply/support cable (H) in canopy (D) and place cano-
py plate (N) in canopy (D). Install screws w/lock washers (O)
to secure plate.
CAUTION: BE SURE NOT TO PINCH THE SUPPLY/SUPPORT CABLE IN
BETWEEN THE CANOPY (D) AND THE CANOPY PLATE (N).
A341
Brindille Glass Pendant Vintage Platinum 161080
Page 1 of 2
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
A
(Figure 2)
C
B
D
E
G
H
F
(Continued)
O
N
G
D
H
F Fixture
G Canopy Gripper
H Supply/Support Cable
N Canopy Plate
O Screws w/ Lock Washers
(Figure 1)