Hubbardton Forge 137530 - Manual (Page 4)

Assembly & Installation Instructions
A178
Ellipse Circular Adjustable Pendant 13-7530 Page 4 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 21364 Rev A
11. Install the other two 10-32 screws (J).
12. Using suitable wire connectors (not provided), connect fixture wires to supply wires (white to white supply, black
to black supply, and bare copper to bare copper or green supply along with green lead (N) from the support ring).
Push wires back into outlet box.
Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.
13. Slide fixture canopy (Q) against ceiling, and secure with threaded button.
14. Once the fixture is fastened to the ceiling, tighten one clutch set screw (T) firmly with hex wrench provided. Make
any needed height adjustments to level the fixture, then tighten the other two set screws. Only after all three set
screws (T) are tight should you install the glass.
15. Refer to instructions below to install glass and light bulb.
Install Glass (Figure 7)
Component Parts
V Bulb Shield (9)
W Bulb (supplied) (9)
X Washer
(9)
Y Glass (9)
Z Socket (9)
1. Install bulb (supplied). Be careful not to
touch bulb with bare hands; oil from the
hands will dramatically reduce bulb life.
2. Place glass (Y) over socket (Z).
3. Place washer (X) over socket (Z) until it
rests on the bottom inside of glass (Y).
4. Thread bulb shield (V) onto Socket (Z).
Future bulb changes may be accomplished
by snapping glass bulb shield on and off
rather than unthreading the holder.
5. Restore electricity at the main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 7)