Hubbardton Forge 136605 - Manual (Page 4)

Assembly & Installation Instructions
A230
For Wren Five Light Pendant 13-6605 Page 4 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 24158 Rev A
To Install Glass with G9 Option (Figure 6)
Component Parts
Q Glass (5)
R Socket (5)
S Bulb (Included) (5)
T Bulb Shield (5)
U Spacer
(5)
1. Install light bulb (S). Be careful not to touch bulb with bare hands; oil from the
hands will dramatically reduce bulb life.
2. Slip glass (Q) over socket (R).
3. Place spacer (U) on bulb shield (T) (note orientation of spacer).
4. Thread bulb shield (T) onto socket (R) (be careful not to over tighten). Future
bulb changes may be accomplished by snapping glass portion of barrier on and
off rather than unthreading the holder.
5. Restore electricity at main breaker.
To Install Double Glass with G9 Option (Figure 7)
Component Parts
Q Glass (5)
R Socket (5)
S Bulb (Included) (5)
T Bulb Shield (5)
U Spacer
(5)
V Inner Glass (5)
W Retaining Ring (5)
X Retaining Ring Tool
1. Install light bulb (S). Be careful not to touch bulb with bare hands; oil from the hands
will dramatically reduce bulb life.
2. Slip glass (Q), inner glass (V) & spacer (U) (note orientation of spacer) over
socket (R).
3. Thread retaining ring (W) onto socket (R) using provided retaining ring tool (X).
4. Thread bulb shield (T) onto socket (R) (be careful not to over tighten). Future bulb
changes may be accomplished by snapping glass portion of barrier on and off rather
than unthreading the holder.
5. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the
dealer from which you purchased this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 6)
(Figure 7)