Allied Telesis AT-S70 - Manual (Page 96)

Chapter 8: Operations, Administration, and Maintenance (OAM)
96
Displaying OAM Information and Statistics
This section contains the procedures on how to display the OAM
information and statistics on the local module.
Displaying Local
OAM
Information
To display the status on the local OAM, perform the following procedure:
1. From the Main Menu, select Module Status and Configuration.
The Module Status and Configuration Menu, as shown in Figure 2 on
page 91, is displayed.
2. Select a line card on which you want to configure.
3. Press .
The Module Configuration Menu, as shown in Figure 4 on page 92, is
displayed.
4. Select the port that you want to show information of the OAM
operations on.
5. Press .
The Port Management Menu, as shown in Figure 6 on page 92, is
displayed.
6. From the Port Management Menu, select OAM Configurations.
The OAM Configuration Menu, as shown in Figure 7 on page 93, is
displayed.
7. From the OAM Configuration Menu, select the Show Local OAM
Information Menu.