Allied Telesis AT-S70 - Manual (Page 107)

AT-S70 Management Software User’s Guide
107
The Port Management Menu, as shown in Figure 6 on page 92, is
displayed.
6. From the Port Management Menu, select OAM Configurations.
The OAM Configuration Menu, as shown in Figure 7 on page 93, is
displayed.
7. From the OAM Configuration Menu, select the OAM Loopback Test
Menu.
8. The OAM Loopback Test Menu, as shown in Figure 41 on page 106, is
displayed.
9. From the OAM Loopback Test Menu, select Start Loopback Test to
initiate loopback test, or select Stop Loopback Test to terminate
remote loopback with an OAM peer. The default is terminated.
10. Press or select the “Return to ...” option at the bottom of the
menu, to save the settings and return to the previous menu.
Displaying or
Clearing
Loopback Test
Statistics
To display or to clear the OAM loopback test statistics, perform the
following procedure:
1. From the Main Menu, select Module Status and Configuration.
The Module Status and Configuration Menu, as shown in Figure 2 on
page 91, is displayed.
2. Select a line card on which you want to configure.
3. Press .
The Module Configuration Menu, as shown in Figure 4 on page 92, is
displayed.
4. Select the port that you want to configure the OAM operations on.
5. Press .
The Port Management Menu, as shown in Figure 6 on page 92, is
displayed.
6. From the Port Management Menu, select OAM Configurations.
The OAM Configuration Menu, as shown in Figure 7 on page 93, is
displayed.
7. From the OAM Configuration Menu, select the OAM Loopback Test
Menu.