Allied Telesis AT-S70 - Manual (Page 105)

AT-S70 Management Software User’s Guide
105
OAM Loopback Test
This section contains the procedures on how to manage the OAM
loopback test.
Enabling or
Disabling Remote
Loopback Test
To enable or disable the OAM remote loopback test, perform the following
procedure:
1. From the Main Menu, select Module Status and Configuration.
The Module Status and Configuration Menu, as shown in Figure 2 on
page 91, is displayed.
2. Select a line card on which you want to configure.
3. Press .
The Module Configuration Menu, as shown in Figure 4 on page 92, is
displayed.
4. Select the port that you want to configure the OAM operations on.
5. Press .
The Port Management Menu, as shown in Figure 6 on page 92, is
displayed.
6. From the Port Management Menu, select OAM Configurations.
The OAM Configuration Menu, as shown in Figure 7 on page 93, is
displayed.
7. From the OAM Configuration Menu, select the OAM Loopback Test
Menu.