Allied Telesis AT-S86 User Manual
Management software, User’s guide
Table of contents
Document Outline
- Contents
- Figure 1. Main Page 16
- Figure 2. IP Setup Page 20
- Figure 3. Save Configuration Page 21
- Figure 4. Administration Page 23
- Figure 5. Management Page 26
- Figure 6. IP Access List Page 28
- Figure 7. Reboot Page 31
- Figure 8. Save Configuration Page 32
- Figure 9. Physical Interface Page 34
- Figure 10. Bandwidth Control Page 38
- Figure 11. (SNMP) Community Table Page 44
- Figure 12. (SNMP) Host Table Page 45
- Figure 13. (SNMP) Trap Setting Page 47
- Figure 14. Static Port Trunk Example 50
- Figure 15. Trunking Page 52
- Figure 16. Trunk Ports Selected 52
- Figure 17. Mirroring Page 59
- Figure 18. Ingress Ports Selected 60
- Figure 19. Egress Ports Selected 60
- Figure 20. Port-Based VLAN Page 69
- Figure 21. Port-based VLAN Ports Selected 70
- Figure 22. Tagged VLAN Page 72
- Figure 23. Add Tagged VLAN Page 73
- Figure 24. Tagged VLAN Ports Selected 74
- Figure 25. VLAN Mode Page 76
- Figure 26. Default Port VLAN & CoS Page 84
- Figure 27. CoS Page 86
- Figure 28. IGMP Snooping Page 92
- Figure 29. Point-to-Point Ports 99
- Figure 30. Edge Port 100
- Figure 31. Point-to-Point and Edge Port 100
- Figure 32. VLAN Fragmentation 101
- Figure 33. Spanning Tree Page 102
- Figure 34. Port Access Control Page 111
- Figure 35. Port Access Control Status Page 114
- Figure 36. Dial-In User Page 116
- Figure 37. RADIUS Page 121
- Figure 38. Traffic Comparison Chart Page 125
- Figure 39. Sample Traffic Comparison Chart 128
- Figure 40. Error Group Chart Page 129
- Figure 41. Sample Error Chart 130
- Figure 42. Historical Status Chart 131
- Figure 43. Sample Historical Status Chart 133
- Figure 44. Dynamic Addresses Page 138
- Figure 45. Dynamic MAC Addresses Associated with a Port 139
- Figure 46. Dynamic MAC Addresses Associated with a VLAN ID 139
- Figure 47. Dynamic MAC Addresses Associated with a MAC Address 140
- Figure 48. Static Addresses Page 142
- Figure 49. Firmware Upgrade Page 146
- Figures
- Table 1. Default Mappings of IEEE 802.1p Priority Levels to Priority Queues 81
- Table 2. Customized Mappings of IEEE 802.1p Priority Levels to Priority Queues 81
- Table 3. Example of Weighted Round Robin Priority 83
- Table 4. Bridge Priority Value Increments 95
- Table 5. STP Auto Port Costs 96
- Table 6. RSTP Auto Port Costs 96
- Table 7. RSTP Auto Port Trunk Costs 96
- Table 8. Port Priority Value Increments 97
- Tables
- Preface
- Chapter 1
- Getting Started
- Chapter 2
- Basic Switch Parameters
- Configuring the IP Address, Subnet Mask, and Gateway Address
- Enabling or Disabling DHCP
- Configuring System Administration Information
- Configuring the System Management Information
- Setting Up IP Address Access
- Rebooting the Switch
- Returning the AT-S86 Management Software to the Default Values
- Chapter 3
- Port Configuration
- Chapter 4
- SNMP
- Chapter 5
- Port Trunking
- Chapter 6
- Port Mirroring
- Chapter 7
- VLANs
- Chapter 8
- Class of Service (CoS)
- Chapter 9
- IGMP
- Chapter 10
- STP and RSTP
- Chapter 11
- Security
- Chapter 12
- Statistics
- Chapter 13
- MAC Addresses
- Chapter 14
- Downloading New Management Software
- Index