Allied Telesis AT-S86 - Manual (Page 22)

Chapter 2: Basic Switch Parameters
22
Enabling or Disabling DHCP
To enable or disable the DHCP client, perform the following procedure:
1. From the main menu, select System > IP Setup.
The IP Setup Page is shown in Figure 2 on page 20.
2. From the DHCP Client list, choose Enabled or Disabled.
The default setting is disabled.
Note
If you lose connectivity after enabling DHCP or to determine the
switch’s new IP address in the future, use the SSM Utility. You can
access the utility in one of the following ways:
- Click the SSM Utility link on the AT-FS750/48 Fast Ethernet Switch
CD, and on the SSM Utility page, click the SSM Utility link.
- Download the SSM Utility files and documentation located in the
SSM Utility folder on the AT-FS750/48 Fast Ethernet Switch CD.
- Download the SSM Utility files and documentation from the Allied
Telesis website, www.alliedtelesis.com.