Allied Telesis AT-S86 - Manual (Page 142)

Chapter 13: MAC Addresses
142
Working with Static MAC Addresses
This section contains the following procedures:
ˆ “Adding a Static MAC Address” on page 142
ˆ “Modifying a Static MAC Address” on page 143
ˆ “Removing a Static MAC Address” on page 143
Adding a Static
MAC Address
To add a static MAC address, perform the following procedure:
1. From the main menu, select Bridge > Static Addresses.
The Static Addresses page is shown in Figure 48.
Figure 48. Static Addresses Page
Any existing static MAC addresses are shown in the table in the
middle of the page.
2. Click Add.
3. In the MAC Address field, enter the static MAC address.
4. In the VLAN ID field, enter the ID of the VLAN where the MAC address
is connected.
5. From the Port Selection list, select the port that you want to associate
with that MAC address.
6. From the Discard on list, select one of the following: