Allied Telesis AT-S86 - Manual (Page 32)

Chapter 2: Basic Switch Parameters
32
Returning the AT-S86 Management Software to the Default Values
To restore the management software to the factory default values, perform
the following procedure:
1. From the main menu, select Save Configuration.
The Save Configuration page is shown in Figure 8.
Figure 8. Save Configuration Page
Note
After the system defaults are restored, the switch is automatically
rebooted and you lose your connection to the switch.
Refer to “Starting a Management Session” on page 16 for
information about how to establish a new connection to the switch.
2. Click Restore to restore the factory defaults.
Note
The reboot process that occurs after the system defaults are
restored stops network traffic.