Allied Telesis Broadcom Advanced Control Suite 3 - Manual (Page 76)

Chapter 2: Configuring Teaming
76
To specify different values, click the desired probe interval in the
Probe interval (seconds) list and click the desired maximum number
of probe retries in the Probe maximum retries list.
Figure 37. Manage Teams Page: Edit Teams Tab
7. Set the Probe VLAN ID to correspond with the VLAN where the probe
target(s) resides.
This step applies the appropriate VLAN tag to the link packet based on
the shared configuration of the attached switch port(s).
Note
Each LiveLink enabled team can only communicate with Probe
Targets on a single VLAN. Also, VLAN ID 0 is equivalent to an
untagged network.
8. Select Probe Target 1 and type the target IP address for one or all of
the probe targets.