Allied Telesis Broadcom Advanced Control Suite 3 - Manual (Page 74)

Chapter 2: Configuring Teaming
74
Deleting a VLAN
To delete a VLAN in Expert Mode, do the following:
1. Click the Team Management button at the bottom of the BACS 3
window, or from the View menu, select Navigate, then Team
Management.
2. Select the VLAN to delete.
3. From the Teams menu, select Remove VLAN.
4. Click Apply.
5. Click Yes when the message is displayed indicating that the network
connection will be temporarily interrupted.
Note
If you delete a team, any VLANs configured for that team are also
deleted.
Configuring
LiveLink
LiveLink is a feature of BASP that is available for the Smart Load
Balancing (SLB) and SLB (Auto-Fallback Disable) type of teaming. The
purpose of LiveLink is to detect link loss beyond the switch and to route
traffic only through team members that have a live link.
Read the following notes before you attempt to configure LiveLink.
Note
Before you configure LiveLink, review the description of the LiveLink
feature. Also verify that each probe target you plan to specify is
available and working. If the IP address of the probe target changes,
you must reconfigure LiveLink. If the MAC address of the probe
target changes, you must restart the team.
Note
A probe target must be on the same subnet as the team, have a
valid statically-assigned IP address, (not a broadcast, multicast, or
unicast) and be highly available (always on).
Note
To ensure network connectivity to the probe target, ping the probe
target from the team.