Allied Telesis Broadcom Advanced Control Suite 3 - Manual (Page 17)

Broadcom Advanced Control Suite 3 User’s Guide
17
Configuring
BACS User
Interface Options
This section describes how to enable and disable the BACS Tray icon.
After the program is installed, BACS 3 places an icon in the Windows
taskbar. Use the Options window to turn this icon on or off.
To enable or disable the BACS tray icon, do the following:
1. From the Tools menu, select Options.
2. In the Options window, select General.
3. Select or clear Enable Tray Icon.
The option is enabled by default.
4. Click OK.
Setting User
Interface
Appearance
By default, the BACS User Interface is set to x, y, and z. You can
customize the appearance of the BACS 3 interface. In addition, you can
reset the user interface to its default values.
To change the interface appearance, do the following:
1. From the Tools menu, select Options.
2. In the Options window, select Appearance.
3. Choose the appearance settings. Click Apply to set changes. Click
OK to set changes and close the Options window.
To reset the interface to the default appearance, do the following:
1. From the Tools menu, select Options.
2. In the Options window, select General.
3. Click Restore Default.
4. Close and then restart BACS 3.
Viewing Vital
Signs
The Vital Signs section of the Information tab has useful information
about the network adapters that are installed in your system, such as the
link status of the adapter and general network connectivity.
To view Vital Signs information for any installed network adapter, click the
name of the adapter listed in the Device Management pane, then click the
Information tab. The Device Management By Type Page is displayed.
See Figure 4 on page 18.
 If the Information tab is not visible, then do the following. From the
View menu, select Navigate, Device Management, and then
Information.