Allied Telesis Broadcom Advanced Control Suite 3 - Manual (Page 55)

Broadcom Advanced Control Suite 3 User’s Guide
55
15. Click the probe target at the top of the list, click Edit Target IP
Address, type the target IP address in the IP Address box for one or
all probe targets, and then click OK. Click Next.
The Creating/Modifying a Team: Configuring LiveLink Page (continued
2) is displayed. See Figure 22 on page 56.
Note
Only the first probe target is required. You can specify up to three
additional probe targets to serve as backups by assigning IP
addresses to the other probe targets.
Figure 21. Creating/Modifying a Team: Configuring LiveLink Page
(continued 1)
16. Select a listed team member, click Edit Member IP Address, and then
type the member IP address in the IP Address box.
Repeat this step for all listed team members and then click OK. Click
Next.