Allied Telesis AT-S94 User Manual
Page 210
Page 210
Allied Telesis
AT-S94 Management Software Web Browser Interface User’s Guide
•
Link Local Interface — If Link Local is selected as the supported IPv6 Address Type, indicates the
supported interface. The possible field values are:
–
VLAN 1 — Indicates that VLAN 1 is supported.
–
Tunnel 1 — Indicates that ISATAP tunneling (Tunnel 1) mechanism is supported.
•
TFTP Operation — Defines the type of TFTP operation and the type of file. The possible values are:
–
Download — Downloads a firmware or configuration file, depending on the selection below.
–
Upload — Uploads a firmware or configuration file, depending on the selection below.
–
Firmware — Device downloads or uploads a firmware file, depending on the selection above.
–
Configuration — Device downloads or uploads a configuration file, depending on the selection above.
•
Source File Name — Specifies the file to be uploaded or downloaded.
•
Destination File — Specifies file types, as described below.
If the TFTP Operation is Firmware, the possible values are:
–
Software Image — Boots the Image file.
–
Boot File — Copies the boot file from the TFTP server to the device.
If the TFTP Operation is Configuration, the possible values are:
–
Running Configuration — Contains the configuration currently valid on the device.
–
Starting Configuration — Contains the configuration that is valid following system startup or reboot.
Note
The configuration file is copied only to the Master Unit, since this unit controls the entire stack. The
configuration file is automatically synchronized with the configuration file on the Secondary Master Unit,
so that in the event of failure of the Master Unit, the Secondary Master Unit takes over immediately with
the same configuration information.
•
TFTP Server IP Address — Specifies the TFTP Server IP Address from which files are downloaded.
To download or upload TFTP Files:
1.
Select the TFTP Operation type: upload or download; firmware or configuration file.
2.
Define the Source file and Destination file type.
3.
Click Apply.
In the Copy Files section, network administrators can copy firmware or configuration files from one device to
another.
•
Copy Master Firmware — Copies the Firmware or the Boot file from the Stacking Master.
–
Software Image — Downloads the Image file.
•
Destination Unit — Downloads firmware or the Boot file to the designated unit. The values are:
–
All — Copies the Firmware or the Boot file to all stacking members.
To copy firmware:
1.
Click Copy Master Firmware. The copy firmware parameters are activated.
2.
Select the Source and the Destination Unit.
3.
Click Apply.